SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2009S2000 BASEREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLVSA (VEHICLE STABILITY ASSIST) SYSTEM COMPONENTSVSA SENSOR NEUTRAL POSITION MEMORIZATION
2009 Honda S2000 Base

VSA Sensor Neutral Position Memorization

2009 Honda S2000 BaseSECTION VSA Sensor Neutral Position Memorization
NOTE: Do not press the brake pedal during this procedure.
  1. Slowly drive the vehicle in a straight line without operating the steering wheel for 10 ft (3 m) or more, then park the vehicle on a flat and level surface while holding the steering wheel at straight position.
  2. With the ignition switch in LOCK (0), connect the HDS to the data link connector (DLC) (A) under the driver's side of the dashboard.
    Fig 1: Identifying Data Link Connector (DLC) Location
    G06232200Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Turn the ignition switch to ON (II).
  4. Make sure the HDS communicates with the vehicle and the VSA modulator-control unit. If it doesn't, troubleshoot the DLC circuit (see DLC CIRCUIT TROUBLESHOOTING ).
  5. Select VSA ADJUSTMENT with the HDS, and follow the screen prompts.
    NOTE: See the HDS Help menu for specific instructions.
  6. Turn the ignition switch to LOCK (0).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.