Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
'06-09 model
2009 Honda S2000 BaseSECTION '06-09 model
- Remove the steering column covers (see STEERING COLUMN REMOVAL AND INSTALLATION ).
- Disconnect the 7P connector (A) from the immobilizer control unit-receiver (B).
- Disconnect the 7P connector (C) from the ignition key switch.
- Remove the four screws, and remove the immobilizer control unit-receiver from the ignition key cylinder.
- Install in the reverse order of removal.
- After replacement, make sure the immobilizer indicator blinks correctly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.