Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Honda Element SC, StandardFACTORY OEM SERVICE PROCEDURE
Gauge Control Module Replacement
- Remove the driver's dashboard panel (see DRIVER'S DASHBOARD PANEL REMOVAL/INSTALLATION ).
- Place a clean shop towel under the gauge control module to prevent scratching the steering column or dashboard.
- Remove the four mounting screws from the gauge control module (A).
- Disconnect the connector (B), and remove the gauge control module.
- Install the gauge control module in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.