2009 Honda Element SC, AutomaticFACTORY OEM SERVICE PROCEDURE

A/C Pressure Sensor

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Honda Crosstour, 2014 Honda Crosstour, 2013 Honda Crosstour, 2012 Honda Crosstour, and 2011 Honda Accord Crosstour. However, it is still accessible from the selected car via links, so may be relevant.

The A/C pressure sensor converts A/C pressure into electrical signals to the PCM.

A/C PRESSURE SENSOR REFERENCE CHART

A/C System Pressure Sensor Output Voltage (V out) System Operation
Abnormally low pressure: Below 196 kPa (2.00 kgf/cm2 , 28.4 psi) Below 0.685 V The PCM disengages the A/C compressor clutch. The radiator and A/C condenser fans operate based on engine coolant temperature
Normal operating pressure:
  • Above 196 kPa (2.00 kgf/cm2 , 28.4 psi)
  • Below 1, 470 kPa (14.99 kgf/cm2 , 213.2 psi)
0.686 V to 1.944 V The PCM cycles the A/C compressor clutch based on cooling demand. The radiator and A/C condenser fans operate at low speed unless the engine coolant temperature exceeds 206 Β°F (97 Β°C)
High operating pressure:
  • Above 1, 470 kPa (14.99 kgf/cm2 , 213.2 psi)
  • Below 3, 138 kPa (32.00 kgf/cm2 , 455.1 psi)
1.945 V to 4.575 V The PCM cycles the A/C compressor clutch based on cooling demand. The radiator and A/C condenser fans operate at high speed.
Abnormally high pressure: More than 3, 138 kPa (32.00 kgf/cm2 , 455.1 psi) Above 4.575 V The PCM disengages the A/C compressor clutch. The radiator and A/C condenser fans operate based on engine coolant temperature.

The response of the A/C pressure sensor is shown in the graph.

NOTE: When the refrigerant is below 196 kPa (2.00 kgf/cm2 , 28.4 psi) or above 3, 138 kPa (32 00 kgf/cm2 , 455.1 psi), the PCM turns the A/C compressor relay off to protect the A/C compressor. When the refrigerant pressure is above 1, 470 kPa (14 99 kgf/cm2 , 213.2 psi), the PCM switches the radiator and A/C condenser fans to high speed.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.