Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Honda Element SC, AutomaticFACTORY OEM SERVICE PROCEDURE
Mode Control Motor Test
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Honda Crosstour, 2014 Honda Crosstour, 2013 Honda Crosstour, 2012 Honda Crosstour, and 2011 Honda Accord Crosstour. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools Required
Backprobe Set 07SAZ-001000A (2)
NOTE:
Before testing the motor, check for climate control DTCs (see HOW TO CHECK FOR DTCS WITH THE HDS
).
- Disconnect the 7P connector from the mode control motor.NOTE: Incorrectly applying power and ground to the mode control motor will damage it. Follow the instructions carefully.
- Connect battery power to terminal No. 7 of the mode control motor/and ground terminal No. 6; the mode control motor should run, and stop at Defrost, if it does not, reverse the connections; the mode control motor should run, and stop at Vent. When the mode control motor stops running, disconnect battery power immediately.
- If the mode control motor did not run in step 2, remove it, then check the mode control linkage and door for smooth movement.
- If the linkage and door move smoothly, replace the mode control motor (see MODE CONTROL MOTOR REPLACEMENT ).
- If the linkage or door sticks or binds, repair them as needed.
- If the mode control motor runs smoothly, go to step 4.
- Measure the resistance between terminals No. 1 and No. 3 of the mode control motor. It should be between 4.2 and 7.8 kΩ.
- Reconnect the mode control motor 7P connector, then turn the ignition switch to ON (II).
- Using the backprobe set (07SAZ-001000A), measure the voltage between terminals No. 2 and No. 1 of the 7P connector.
Vent: About 0.5 V
Defrost: About 4.5 V
- If either the resistance or the voltage readings are not as specified, replace the mode control motor (see MODE CONTROL MOTOR REPLACEMENT ).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
