WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Honda Odyssey, 2016 Honda Odyssey, 2015 Honda Odyssey, 2014 Honda Odyssey, and 2013 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Do this procedure in a clean place free from dirt.
Wear latex or vinyl gloves when doing this procedure (Do not use fabric gloves).
When removing the navigation display visor, do not touch the LCD facing.
If there is dirt on the LCD facing, clean it using compressed air.
When installing the navigation display visor onto the LCD assembly, be careful not to touch the LCD facing.
Check that the navigation display visor and the LCD assembly are properly installed.
Since the LCD assembly and the navigation display visor are installed at an angle, be sure that the screws are properly seated. If not properly seated, tighten the screws.
Check that the navigation display unit assembly has no damage.
When removing the navigation display visor, do not hold the LCD facing down.

Remove the navigation display unit (see NAVIGATION DISPLAY UNIT REMOVAL/INSTALLATION ).
Remove the screws and the LCD assembly (A) from the navigation display visor (B).

Fig 1: Locating LCD Assembly And Navigation Display Visor
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the navigation display visor reverse order of removal.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Navigation Display Visor Removal/Installation

Use the Manual With the Right Hardware

When to See a Mechanic