Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Honda Element SC, AutomaticFACTORY OEM SERVICE PROCEDURE
Climate Control Unit Removal/Installation
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Honda Odyssey, 2016 Honda Odyssey, 2015 Honda Odyssey, 2014 Honda Odyssey, and 2013 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the center panel (see PASSENGER'S MIDDLE PANEL REMOVAL/INSTALLATION ).
- Remove the self-tapping screws and the climate control unit (A).
- Install the control unit in the reverse order of removal. After installation, operate the various functions to see whether it works properly.
- Run the self-diagnostic function to confirm that there are no problems in the system (see HOW TO USE THE CLIMATE CONTROL UNIT SELF-DIAGNOSTIC FUNCTION WITHOUT THE HDS ).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.