2009 Honda Element SC, AutomaticFACTORY OEM SERVICE PROCEDURE

DTC P0630: VIN Not Programmed or Mismatch: General Description

The engine control module (ECM)/powertrain control module (PCM) stores a vehicle identification number (VIN) in the keep-alive memory and outputs the VIN according to the command from the HDS.

The VIN for each vehicle is registered to the ECM/PCM using the HDS. The registered VIN is read by the CPU from the keep-alive memory after the ignition is turned on or after the Clear command is executed.

If the VIN is not registered in the keep-alive memory when the ignition is turned on or when the Clear command is executed, it is detected as a VIN unregistered condition and a DTC is stored.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.