Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSHONDA2009CR-V EX, 2.4 RE3REPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTNAVIGATION SYSTEMVOICE CONTROL SWITCH TEST - ('07-09 MODELS)
2009 Honda CR-V EX, 2.4 RE3
Voice Control Switch Test - ('07-09 models)
2009 Honda CR-V EX, 2.4 RE3SECTION Voice Control Switch Test - ('07-09 models)
- Remove the voice control switch (see VOICE CONTROL SWITCH REPLACEMENT - ('07-09 MODELS)Β ).
- Measure the resistance between the terminals No. 2 and No. 4 in each switch position according to the table.RESISTANCE CHART
Position Resistance No button pressed About 10 kΞ© Navigation TALK button About 2.2 kΞ© Navigation BACK button About 650 Ξ© - If the resistance is not as specified, replace the voice control switch (see VOICE CONTROL SWITCH REPLACEMENT - ('07-09 MODELS)Β ).
- Use a diode tester between the terminals in each switch position according to the table.
- If the diode test is bad, replace the switch (see VOICE CONTROL SWITCH REPLACEMENT - ('07-09 MODELS)Β ).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.