SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2009CR-V EX, 2.4 RE3REPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTNAVIGATION SYSTEMGENERAL TROUBLESHOOTING INFORMATION - ('07-09 MODELS)ENTERING SECURITY CODE
2009 Honda CR-V EX, 2.4 RE3

Entering Security Code

2009 Honda CR-V EX, 2.4 RE3SECTION Entering Security Code

Any time the navigation system loses power, you need to enter the 4-digit anti-theft code on the navigation system display. This 4-digit code is located on a small code card that was given to the customer. Enter the 4-digit code, then select Done.

If the navigation system anti-theft code is missing, use the interactive Network (iN) to look it up. You need the serial number for the audio-navigation unit to do this. You can view the serial number by entering the diagnostic mode. Navi ECU diagnostic screen. This gives you the serial number without removing the audio-navigation unit.

The iN may display more than one code for a given serial number. This is because serial numbers are not unique. You may have to try more than one 4-digit code. If no code is shown, or if the code(s) given do not work in the audio-navigation unit, contact the Automobile Warranty department. If the code 0000 works, replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION - ('07-09 MODELS) ).

When replacing the audio-navigation unit, make sure you give the customer the new anti-theft security code.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.