Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Honda S2000 BaseFACTORY OEM SERVICE PROCEDURE
Enable Conditions
ENABLE CONDITIONS
| Condition | Minimum | Maximum |
|---|---|---|
| Engine coolant temperature | 156 °F (69 °C) | - |
| Intake air temperature | 20 °F (-7 °C) | - |
| Engine speed | 800 rpm | 4,700 rpm |
| MAP value | 20 kPa (6.0 in.Hg, 150 mmHg) | - |
| Fuel feedback | Closed loop | |
| Monitoring priority | P0420, P0456, P0457, P0497 | |
| No active DTCs | P0107, P0108, P0112, P0113, P0117, P0118, P0134, P0135, P0137, P0138, P0300, P0301, P0302, P0303, P0304, P0335, P0339, P0443, P0496, P1109, P1128, P1129, P1157, P1172, P2195, P2227, P2228, P2229, P2238, P2252, P2270, P2271, P2646, P2647, P2648, P2649 | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.