Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Honda S2000 BaseFACTORY OEM SERVICE PROCEDURE
Engine Lubrication System
ENGINE LUBRICATION STANDARDS AND SERVICE LIMITS SPECIFICATIONS TABLE
| Item | Measurement | Qualification | Standard or New | Service Limit |
|---|---|---|---|---|
| Engine oil | Capacity | Engine overhaul | 5.6 L (5.9 US qt) | |
| Oil change including filter | 4.8 L (5.1 US qt) | |||
| Oil change without filter | 4.5 L (4.8 US qt) | |||
| Oil pump | Inner-to-outer rotor clearance | - | 0.02-0.014 mm (0.001-0.006 in.) | 0.20 mm (0.008 in.) |
| Pump housing-to-outer rotor clearance | - | 0.15-0.21 mm (0.006-0.008 in.) | 0.23 mm (0.009 in.) | |
| Pump housing-to-outer rotor axial clearance | - | 0.02-0.07 mm (0.001-0.003 in.) | 0.12 mm (0.005 in.) | |
| Oil pressure with oil temperature at 176Β°F (80Β°C) | At idle | 250 kPa (2.5 kgf/cm2 , 36 psi) | ||
| At 3, 000 RPM | 590 kPa (6.0 kgf/cm2 , 85 psi) | |||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
