Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
'08-10 Models J35A7 engine
2008 Honda Odyssey EXSECTION '08-10 Models J35A7 engine
- Remove the lower glove box (see LOWER GLOVE BOX REMOVAL/INSTALLATION ), and the right kick panel (see step 2 on TRIM REMOVAL/INSTALLATION - DOOR AREAS ).
- Disconnect the engine mount control unit 16P connector (A).
- Remove the engine mount control unit (B).
- Install the parts in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.