Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
'08-10 models with premium audio system
2008 Honda Odyssey EXSECTION '08-10 models with premium audio system
SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ), and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service.
- Remove the driver's airbag assembly (see DRIVER'S AIRBAG REPLACEMENT ).
- Disconnect the 13P connector (A) from the cable reel (B).
- Measure the resistance between terminals No. 18 and No. 19 in each switch position according to the table.RESISTANCE CHART
Position Resistance No button pressed About 10 kΞ© MODE About 3.7 kΞ© CH (+) About 1.7 kΞ© CH(-) About 775 Ξ© (VOL.UP) About 357 Ξ© (VOL.DOWN) About 100 Ξ© - If the resistance is not as specified, replace the audio remote switch (see STEERING WHEEL DISASSEMBLY/REASSEMBLY ).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.