Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Audio unit button illumination does not work ('08-10 models)
- Check the vehicle battery condition first.
- Check the connectors for poor connections or loose terminals.
- Turn the ignition switch to ON (II).
- Turn the combination lighting switch to the parking light position.
- Check the illumination of the audio unit buttons.
Are the buttons illuminated?
YES -Intermittent problem: the audio unit is OK at this time. Check for loose or poor connections at audio unit connector A(17P).
NO -Go to step 4.
- Check the illumination of several other buttons not related to the audio system.
Are the buttons illuminated?
YES -Go to step 5.
NO -Troubleshoot the interior lights. Start by checking the No. 7 (7.5 A) fuse in the passenger's under-dash fuse/relay box. If the fuse is OK, check for an open in the wire between the passenger's under-dash fuse/relay box and the audio unit.
- Turn the ignition switch to LOCK (0).
- Disconnect audio unit connector A (17P).NOTE: Eject all the discs before removing the audio unit to prevent damaging the CD player's load mechanism.
- Disconnect gauge control module connector A (30P).
- Check for continuity between audio unit connector A (17P) terminal No. 1 and gauge control module connector A (30P) terminal No. 19.Fig 1: Checking Continuity Between Audio Unit Connector A (17P) Terminal No. 1 And Gauge Control Module Connector A (30) Terminal No. 19
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES -Go to step 9.
NO -Repair open in the wire between the gauge control module and the audio unit.
- Turn the ignition switch to ON (II).
- With the headlight switch still on, measure the voltage between audio unit connector A (17P) terminal No. 10 and body ground.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there battery voltage?
YES -Check the connections at the audio unit connector A (17P). If all connections are OK, replace the audio unit (see AUDIO UNIT REMOVAL/INSTALLATION ).
NO -Repair open in the wire between the passenger's under-dash fuse/relay box and the audio unit.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.