Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2007 Honda Ridgeline RTLFACTORY OEM SERVICE PROCEDURE

Master Switch Replacement

Remove the driver's door panel (see Remove the driver's door panel (see COMPONENT LOCATION INDEX - FRONT DOOR ).
Remove the four mounting screws, then remove the master switch (A) from the switch panel (B).

Fig 1: Identifying Master Switch And Switch Panel
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install in the reverse order of removal.
Reset the power window control unit (see RESETTING THE POWER WINDOW CONTROL UNIT ).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.