Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Honda Pilot 2WD V6-3.5LFACTORY OEM SERVICE PROCEDURE
Transmission Position Sensor/Switch: Testing and Inspection
Transmission Range Switch Test
1. Make sure you have anti-theft codes for the audio unit and navigation system, then write down the audio presets.
2. Disconnect the negative terminal from the battery, then disconnect the positive terminal.
3. Remove the battery hold-down bracket, and remove the battery and battery tray.
4. Remove the intake manifold cover and the air intake duct.
5. Remove the battery base.
6. Disconnect the transmission range switch connector.
7. Check for continuity between terminals at the switch connector. There should be continuity between the terminals in the following table for each switch position.
8. Transmission range switch test has finished if the test results are OK. If there is no continuity between any terminals, check that the transmission range switch installation. If the switch installation is OK, replace the switch.
1. Make sure you have anti-theft codes for the audio unit and navigation system, then write down the audio presets.
2. Disconnect the negative terminal from the battery, then disconnect the positive terminal.
3. Remove the battery hold-down bracket, and remove the battery and battery tray.
4. Remove the intake manifold cover and the air intake duct.
5. Remove the battery base.
6. Disconnect the transmission range switch connector.
7. Check for continuity between terminals at the switch connector. There should be continuity between the terminals in the following table for each switch position.
8. Transmission range switch test has finished if the test results are OK. If there is no continuity between any terminals, check that the transmission range switch installation. If the switch installation is OK, replace the switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.