Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Honda Pilot 2WD V6-3.5LFACTORY OEM SERVICE PROCEDURE
Cruise Control Main Switch Test/Replacement
Cruise Control Main Switch Test/Replacement
1. Remove the switch panel.

2. Disconnect the 13P connector (A), then release the clips of the cruise control main switch, and push the cruise control main switch (B) out of the panel.

3. Check for continuity between the terminals in each switch position according to the table. If there is no continuity, replace indicator bulbs (A) or the switch.
1. Remove the switch panel.
2. Disconnect the 13P connector (A), then release the clips of the cruise control main switch, and push the cruise control main switch (B) out of the panel.
3. Check for continuity between the terminals in each switch position according to the table. If there is no continuity, replace indicator bulbs (A) or the switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
