Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Honda Pilot 2WD V6-3.5LFACTORY OEM SERVICE PROCEDURE
Navigation Module: Service and Repair
Navigation Unit Removal/Installation
1. Remove the navigation DVD.

2. Remove the passenger's seat.
3. Remove the navigation unit bracket (A) from the passenger's seat.
4. Remove the bracket from the navigation unit (B).
5. Install in the reverse order of removal.
6. Do the map matching procedure after servicing.
1. Remove the navigation DVD.
2. Remove the passenger's seat.
3. Remove the navigation unit bracket (A) from the passenger's seat.
4. Remove the bracket from the navigation unit (B).
5. Install in the reverse order of removal.
6. Do the map matching procedure after servicing.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
