2007 Honda Fit Base, StandardFACTORY OEM SERVICE PROCEDURE

Keyless Receiver Unit Input Test

  1. Remove the driver's dashboard under cover (see DRIVER'S DASHBOARD UNDERCOVER REMOVAL/INSTALLATION ).
  2. Remove the mounting nuts and pull down the under-dash fuse/relay box.
  3. Disconnect the 5P connector (A) from the keyless receiver unit (B).
    Fig 1: Identifying Keyless Receiver Unit 5P Connector Terminals
    G05456587Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Inspect the connector and socket terminals to be sure they are all making good contact.
    • If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
    • If the terminals are OK, go to step 5.
  5. Reconnect the connector to the keyless receiver unit, and make these input tests at the connector.
    • If any test indicates a problem, find and correct the cause, then recheck-the system.
    • If all the input tests prove OK, go to step 6
    KEYLESS RECEIVER UNIT INPUT

    Cavity Wire Test condition Test: Desired result Possible cause if result is not obtained
    1 BLK Under all conditions Measure the voltage to ground: There should be less than 0.5 V.
    • Poor ground (G403)
    • An open in the wire
    3 YEL Ignition switch ON (II) Measure the voltage to ground: There should be battery voltage.
    • Blown No. 3 (10 A) fuse in the under-dash fuse/relay box
    • An open in the wire
    5 WHT/ RED Under all conditions Measure the voltage to ground: There should be battery voltage.
    • Blown No. 8 (10 A) fuse in the under-hood fuse/relay box
    • An open in the wire
    2 BLU/ ORN Ignition key out of the ignition. Doors, hood, and tailgate closed Measure the voltage to ground while pressing the keyless remote buttons: Voltage should drop by about 2 V.
    • Faulty keyless receiver unit
    • A short on the wire
  6. Disconnect the connector from the keyless receiver unit, and make this input test at the connector.
    • If any test indicates a problem, find and correct the cause, then recheck the system.
    • If all the input tests prove OK, replace the keyless receiver unit.
KEYLESS RECEIVER UNIT INPUT

Cavity Wire Test condition Test: Desired result Possible cause if result is not obtained
2 BLU/ORN Under all conditions Check for continuity between the No. 2 terminal and the No. 17 terminal of gauge control module connector C (40P). There should be continuity. An open in the wire
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.