Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Honda Fit Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Electronic Throttle Control DTCS
ELECTRONIC THROTTLE CONTROL DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| P0122 | TP Sensor A Circuit Low Voltage |
| P0123 | TP Sensor A Circuit High Voltage |
| P0222 | TP Sensor B Circuit Low Voltage |
| P0223 | TP Sensor B Circuit High Voltage |
| P1683 | Throttle Valve Default Position Spring Performance Problem |
| P1684 | Throttle Valve Return Spring Performance Problem |
| P2101 | Throttle Actuator System Malfunction |
| P2108 | Throttle Actuator Control Module Problem |
| P2118 | Throttle Actuator Current Range/Performance Problem |
| P2122 | APP Sensor A (TP Sensor D) Circuit Low Voltage |
| P2123 | APP Sensor A (TP Sensor D) Circuit High Voltage |
| P2127 | APP Sensor B (TP Sensor E) Circuit Low Voltage |
| P2128 | APP Sensor B (TP Sensor E) Circuit High Voltage |
| P2135 | TP Sensor A/B Incorrect Voltage Correlation |
| P2138 | APP Sensor A/B (TP Sensor D/E) Incorrect Voltage Correlation |
| P2176 | Throttle Actuator Control System Idle Position Not Learned |
| P2552 | Throttle Actuator Control Module Relay Malfunction |
| DTC U0107 | Lost Communication With Throttle Actuator Control Module |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
