Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Honda Fit Base, AutomaticFACTORY OEM SERVICE PROCEDURE
SRS Unit Replacement: Removal
NOTE:
If you are only disconnecting SRS unit connector A, skip step 2.
- Disconnect the negative cable from the battery, then wait for 3 minutes before starting work.
- Disconnect both seat belt tensioner connectors (see step 7 on DISCONNECTING SYSTEM CONNECTORS ) and both lap belt tensioner connectors (see step 10 on DISCONNECTING SYSTEM CONNECTORS ).
- Remove the center console (see CENTER CONSOLE REMOVAL/INSTALLATION ).
- Disconnect SRS unit connector A (28P), SRS unit connector B (28P), and SRS unit connector C (28P) from the SRS unit.
- Remove the TORX bolts (D), then remove the SRS unit.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.