2007 Honda Fit Base, AutomaticFACTORY OEM SERVICE PROCEDURE

With the HDS

  1. Make sure you have the anti-theft code for the audio system.
  2. Turn the ignition switch OFF.
  3. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
    Fig 1: Connecting HDS To DLC
    G05454773Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Turn the ignition switch ON (II).
  5. Make sure the HDS communicates with the ECM/PCM. If it doesn't, go to the DLC circuit troubleshooting (see DLC CIRCUIT TROUBLESHOOTING (PART 1) ).
  6. Turn the ignition switch OFF.
  7. Remove the fuel fill cap to relieve the pressure in the fuel tank.
  8. Turn the ignition switch ON (II).
  9. From the INSPECTION MENU of the HDS, select Fuel Pump OFF, then start the engine, and let it idle until it stalls.
    NOTE:
    • Do not allow the engine to idle above 1,000 rpm or the ECM/PCM will continue to operate the fuel pump.
    • A DTC or a Temporary DTC may be set during this procedure. Check for DTCs, and clear them as needed (see DTC CLEAR ).
  10. Turn the ignition switch OFF.
  11. Disconnect the negative cable from the battery.
  12. Remove the quick-connect fitting cover (A).
    Fig 2: Identifying Quick-Connect Fitting Cover
    G05454774Courtesy of AMERICAN HONDA MOTOR CO., INC.
  13. Check the fuel quick-connect fitting for dirt, and clean it if needed.
  14. Place a rag or shop towel over the quick-connect fitting (A).
    Fig 3: Identifying Quick-Connect Fitting
    G05454775Courtesy of AMERICAN HONDA MOTOR CO., INC.
  15. Disconnect the quick-connect fitting (A): Hold the connector (B) with one hand, and squeeze the retainer tabs (C) with the other hand to release them from the locking tabs (D). Pull the connector off.
    NOTE:
    • Be careful not to damage the line (E) or other parts.
    • Do not use tools.
    • If the connector does not move, keep the retainer tabs pressed down, and alternately pull and push the connector until it comes off easily.
    • Do not remove the retainer from the line; once removed, the retainer must be replaced with a new one.
      • Fig 4: Disconnecting Quick-Connect Fitting
      G05454776Courtesy of AMERICAN HONDA MOTOR CO., INC.
  16. After disconnecting the quick-connect fitting, check it for dirt or damage (see step 4 on FUEL LINE/QUICK-CONNECT FITTING REMOVAL ).
  17. Reconnect the negative cable to the battery, then do this:
    • Enter the anti-theft code for the audio system.
    • Set the clock.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.