Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Honda Element SC, AutomaticFACTORY OEM SERVICE PROCEDURE
Stall Speed Test
- Make sure the transmission fluid is filled to the proper level (see ATF LEVEL CHECK ).
- Apply the parking brake, and block all four wheels.
- Connect the HDS to the DLC (A) located under the driver's side of the dashboard.
- Turn the ignition switch to ON (II), and go to the A/T Data List. Make sure the HDS communicates with the PCM. If it does not, go to the DLC circuit troubleshooting (see DLC CIRCUIT TROUBLESHOOTING ).
- Make sure the A/C switch is OFF.
- Start the engine, and warm it up to normal operating temperature (the radiator fan comes on).
- Shift to D while pressing the brake pedal firmly, then press the accelerator pedal for 6 to 8 seconds, and note the engine speed. Do not move the shift lever or remove your foot off the brake pedal, while raising the engine speed.
- Allow 2 minutes for cooling, then repeat the test with the shift lever in D, 1, and R.NOTE:
Stall Speed rpm:
Specification: 2,100 rpm
Service Limit: 1,950-2,250 rpm
- If the stall speeds are out of the service limit, problems and probable causes are listed in the table.PROBABLE CAUSES CHART
Problem Probable causes Stall speed rpm high in D, 2, 1, and R Stall speed rpm high in 1 Slippage of 1st clutch Stall speed rpm high in 2 Slippage of 2nd clutch Stall speed rpm high in R Slippage of 4th clutch Stall speed rpm low in D, 2, 1, and R
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
