2007 Honda Element SC, AutomaticFACTORY OEM SERVICE PROCEDURE

End Cover Installation

Special Tools Required 

Mainshaft holder 07GAB-PF50101

  1. Install the mainshaft holder onto the mainshaft.
    Fig 1: Installing Mainshaft Holder Onto Mainshaft
    G06267243Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Lubricate the following parts with ATF:
    • Splines and threads of the mainshaft.
    • Splines of the mainshaft idler gear.
    • The old conical spring washer and the old locknut.
  3. Install the mainshaft idler gear (A), the old conical spring washer (B), and the old locknut (C) on the mainshaft (D), and tighten the locknut to 226 N.m (23.0 kgf.m, 166 lbf.ft).
    NOTE:
    • Do not tap the mainshaft idler gear to install.
    • Use a torque wrench to tighten the locknut. Do not use an impact wrench.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.