2007 Honda Element SC, AutomaticFACTORY OEM SERVICE PROCEDURE

Engine Oil Replacement

  1. Warm up the engine.
  2. Remove the drain bolt (A), and drain the engine oil.
    Fig 1: Drain Bolt With Torque Specifications
    G05448753Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Reinstall the drain bolt with a new washer (B).
  4. Refill with the recommended oil (see LUBRICANTS AND FLUIDS ).

    Capacity 

    At Oil Change: 

    4.0 L (4.2 US qt) 

    At Oil Change including Filter: 

    4.2 L (4.4 US qt) 

    After Engine Overhaul: 

    5.3 L (5.6 US qt) 

  5. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2 on page 11-3).
  6. Turn the ignition switch ON (II).
  7. Make sure the HDS communicates with the vehicle and the engine control module (ECM)/powertrain control module (PCM). If it doesn't communicate, troubleshoot the DLC circuit (see DLC CIRCUIT TROUBLESHOOTING ).
  8. Select BODY ELECTRICAL with the HDS.
  9. Select ADJUSTMENT in the GAUGES MENU with the HDS.
  10. Select RESET in the MAINTENANCE MINDER with the HDS.
  11. Select RESETTING THE ENGINE OIL LIFE with the HDS.
    NOTE: If you changed the ATF at the same time with the engine oil, select RESETTING THE ENGINE OIL LIFE AND ATF with the HDS instead.
  12. Run the engine for more than 3 minutes, then check for oil leakage.
  13. Reset the multi-information display (see RESETTING THE MAINTENANCE INFORMATION DISPLAY ).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.