2007 Honda Element SC, AutomaticFACTORY OEM SERVICE PROCEDURE

Passenger's Power Window Switch Test/Replacement

  1. Remove the passenger's door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
  2. Disconnect the 5P connector (A) from the front passenger's power window switch (B).
    Fig 1: Identifying Front Passenger's Power Window Switch
    G05451503Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the two screws and the passenger's power window switch.
    Fig 2: Identifying Passenger's Power Window Switch Terminals
    G05451504Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Check for continuity between the terminals in each switch position according to the table below.
    Fig 3: Identifying Passenger's Power Window Switch Terminals Continuity Table
    G05451505Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. If the continuity is not as specified, replace the switch.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.