2007 Honda Element SC, AutomaticFACTORY OEM SERVICE PROCEDURE

Function Test

  1. Remove the driver's door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
  2. Disconnect the 13P connector (A) from the power mirror switch (B).
    Fig 1: Identifying Power Mirror Switch 13P Connector Terminals
    G05451475Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Choose the appropriate test based on the symptom:
    • Both mirrors don't work, go to step  4.
    • Left mirror doesn't work, go to step  6.
    • Right mirror doesn't work, go to step  7.
  4. Both mirrors 

  5. Measure voltage between the No. 2 terminal and body ground with the ignition switch ON (II). There should be battery voltage.
    • If there is no battery voltage, check for:
      • Blown No. 14 (10 A) fuse in the under-dash fuse/relay box.
      • An open in the BLK/YEL wire.
    • If there is battery voltage, go to step  5.
  6. Check for continuity between the No. 6 terminal and body ground.

    There should be continuity.

    • If there is no continuity, check for:
      • An open in the BLK wire.
      • Poor ground (G501).
    • If there is continuity, check both mirrors individually as described in step  6 and step  7.
  7. Left mirror 

  8. Connect the No. 2 terminal to the No. 10 terminal, and the No. 5 (then No. 12) terminal to No. 6 terminal with jumper wires. The left mirror should tilt down (then swing left) with the ignition switch ON (II).
    • If the mirror does not tilt down (or does not swing left), check for an open in the GRN/WHT (or BLU/WHT) wire between the left mirror and the 13P connector. If the wire is OK, check the left mirror actuator (see POWER MIRROR ACTUATOR TEST  ).
    • If the mirror neither tilts down nor swings left, repair the BLU/BLK wire.
    • If the mirror works properly, check the mirror switch (see POWER MIRROR ACTUATOR TEST  ).
  9. Right mirror 

  10. Connect the No. 2 terminal to the No. 11 terminal, and the No. 5 (then No. 13) terminal to No. 6 terminal with jumper wires. The right mirror should tilt down (then swing left) with the ignition switch ON (II).
    • If the mirror does not tilt down (or does not swing left), check for an open in the GRN/WHT (or WHT/RED) wire between the right mirror and the 13P connector. If the wire is OK, check the right mirror actuator (see POWER MIRROR ACTUATOR TEST  ).
    • If the mirror neither tilts down nor swings left, repair the RED/YEL wire.
    • If the mirror works properly, check the mirror switch (see POWER MIRROR ACTUATOR TEST  ).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.