Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
A/C Signal Circuit Troubleshooting
- Start the engine.
- Turn the blower switch on.
- Turn the A/C switch on.
- Check the A/C CLUTCH in the DATA LIST with the HDS.
Does it indicated ON?
YES - Go to step 5.
NO - Do A/C SYSTEM TEST .
- Check the A/C system.
Does the A/C system operate?
YES - The air conditioning system circuit is OK.
NO - Go to step 6.
- Turn the ignition switch OFF.
- Turn the ignition switch ON (II).
- Activate the A/C CLUTCH in the INSPECTION MENU with the HDS.
Is there a clicking noise from the A/C compressor clutch?
YES - Do A/C SYSTEM TEST .
NO - Go to step 9.
- Momentarily connect under-hood fuse/relay box 14P connector terminal No. 10 to body ground with a jumper wire several times.
Is there a clicking noise from the A/C compressor clutch?
YES - Repair open in the wire between the ECM/PCM (E18) and the A/C clutch relay.
NO - Update the ECM/PCM if it does not have the latest software (see UPDATING THE ECM/PCM ), or substitute a known-good ECM/PCM (see SUBSTITUTING THE ECM/PCM ), then recheck. If the symptom/indication goes away with a known-good ECM/PCM, replace the original ECM/PCM (see ECM/PCM REPLACEMENT ).
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.