Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2007ELEMENT EX, 2.4 YH1, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMINTAKE AIR SYSTEMTHROTTLE BODY TESTTHROTTLE POSITION LEARNING CHECK
2007 Honda Element EX, 2.4 YH1, Automatic
Throttle Position Learning Check
2007 Honda Element EX, 2.4 YH1, AutomaticSECTION Throttle Position Learning Check
NOTE:
If the malfunction indicator lamp (MIL) has been reported on, check for diagnostic trouble codes (DTCs).
- Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
- Turn the ignition switch ON (II).
- Make sure the HDS communicates with the ECM/PCM. If it doesn't, go to DLC CIRCUIT TROUBLESHOOTING ).
- Select the INSPECTION MENU with the HDS.
- Do the TP LEARNING CHECK in the ETCS TEST. If needed, clean the throttle body (see THROTTLE BODY CLEANING ).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.