Throttle Actuator Control Module Replacement

2007 Honda Element EX, 2.4 YH1, AutomaticSECTION Throttle Actuator Control Module Replacement
  1. Push the tab (A), and disconnect the throttle actuator control module 16P connector (B).
    Fig 1: Pushing Tab & Disconnecting Throttle Actuator Control Module 16P Connector
    G05449163Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Remove the bolts (C), and the throttle actuator control module (D).
  3. Install the parts in the reverse order of removal.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.