2006 Honda S2000FACTORY OEM SERVICE PROCEDURE

EVAP Canister Replacement

  1. Raise the vehicle on a lift.
  2. Remove the EVAP canister cover (A).
    Fig 1: Identifying EVAP Canister Cover
    G03693341Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the hoses (A), the FTP sensor 3P connector (B), and the EVAP canister vent shut valve 2P connector (C).
    Fig 2: Identifying Hoses, FTP Sensor 3P Connector & EVAP Canister Vent Shut Valve 2P Connector
    G03693342Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the bolts (D).
  5. Remove the EVAP canister assembly (E).
  6. Remove the canister filter (A).
    Fig 3: Identifying Canister Filter
    G03693343Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Remove the EVAP canister bracket (A).
    Fig 4: Identifying EVAP Canister Bracket
    G03693344Courtesy of AMERICAN HONDA MOTOR CO., INC.
  8. Install the canister in the reverse order of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.