2006 Honda S2000FACTORY OEM SERVICE PROCEDURE

DTC P0420: Catalyst System Efficiency Below Threshold: General Description

The three way catalytic converter (TWC) converts hydrocarbons (HC), carbon monoxide (CO), and oxides of nitrogen (NOx) in the exhaust gas to water vapor, carbon dioxide (CO2), and dinitrogen (N2).

The TWC efficiency does not depend entirely on engine conditions or the deterioration level of the TWC. It can be optimized by stabilizing the secondary HO2S output.

If the TWC deteriorates, the air/fuel ratio downstream of the TWC (the secondary HO2S output) often differs from the target secondary HO2S output, and the status is represented by the parameter (SIGSQRLS).

Therefore, if the SIGSQRLS exceeds a specified value for a set time, a malfunction is detected and a DTC is stored.

MONITOR EXECUTION, SEQUENCE, DURATION, DTC TYPE, OBD STATUS

Execution Once per driving cycle
Sequence None
Duration 50.5 seconds or more
DTC Type Two drive cycles, MIL ON
OBD Status PASSED/FAILED/EXECUTING/OUT OF (TEST) CONDITION
ENABLE CONDITIONS CHART

Condition Minimum Maximum
Engine coolant temperature 156°F (69°C) -
Intake air temperature -13°F (-25°C) -
Estimated TWC temperature 806°F (430°C) -
Engine speed 1,575 rpm 3,500 rpm
MAP value 27 kPa (7.9 in.Hg, 200 mmHg) 63 kPa (18.8 in.Hg, 480 mmHg)
Vehicle speed 4 mph (5 km/h) -
Fuel trim 0.69 1.47
Fuel feedback Closed loop
Monitoring priority P0456, P0457, P0497
No active DTCs P0107, P0108, P0112, P0113, P0117, P0118, P0133, P0134, P0135, P0137, P0138, P0139, P0141, P0171, P0172, P0300, P0301, P0302, P0303, P0304, P0335, P0339, P0443, P0496, P1109, P1128, P1129, P1157, P1172, P2195, P2227, P2228, P2229, P2238, P2252, P2270, P2271, P2646, P2647, P2648, P2649, P2A00
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.