Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Honda S2000 L4-2.2LFACTORY OEM SERVICE PROCEDURE
Refrigerant Oil
REFRIGERANT OIL CAPACITY
Recommended PAG oil KEIHIN SP-10
P/N 38897-P13-A01AH 120 mL (4 fl oz)
P/N 38899-P13-A01 40 mL (1 1/3 fl oz)
A/C COMPRESSOR
For A/C compressor replacement, subtract the volume of oil drained from the removed A/C compressor from 130 mL (4 1/3 fl oz), and drain the calculated volume of oil from the new A/C compressor: 130 mL (4 1/3 fl oz) - Volume of removed A/C compressor = Volume to drain from new A/C compressor.
NOTE: Even if no oil is drained from the removed A/C compressor, don't drain more than 50 mL (1 2/3 fl oz) from the new A/C compressor.
A/C Condenser 25 mL (5/6 fl oz)
Evaporator 40 mL (1 1/3 fl oz)
Line or hose 10 mL (1/3 fl oz)
Receiver/Dryer 10 mL (1/3 fl oz)
Leakage repair 25 mL (5/6 fl oz)
* Add the recommended refrigerant oil in the amount listed if you replace any of the following parts.
* To avoid contamination, do not return the oil to the container once dispensed, and never mix it with other refrigerant oils.
* Immediately after using the oil, reinstall the cap on the container, and seal it to avoid moisture absorption.
* Do not spill the refrigerant oil on the vehicle; it may damage the paint. If it gets on the paint, wash it off immediately.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
