2006 Honda Odyssey EX-LFACTORY OEM SERVICE PROCEDURE

ECT Sensor 1 Replacement

  1. Drain the engine coolant (see COOLANT REPLACEMENT ).
  2. Remove the intake manifold cover (see step 1 in REMOVAL ).
  3. Disconnect the ECT sensor 1 2P connector (A).
    Fig 1: Disconnecting ECT Sensor 1 2P Connector
    G03704380Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove ECT sensor 1 (B).
  5. Install the sensor in the reverse order of removal with a new O-ring (C), then refill the radiator with engine coolant (see COOLANT REPLACEMENT ), and bleed air from the cooling system with the heater valve open.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.