2006 Honda Odyssey EX-LFACTORY OEM SERVICE PROCEDURE

Resonator Removal/Installation

  1. Remove the front bumper (see FRONT BUMPER REMOVAL/INSTALLATION ).
  2. Remove the bolt (A), clips (B), and cover (C).
    Fig 1: Removing Bolt, Clips And Cover
    G03704619Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the intake air duct (D).
  4. Remove the bolts (A), and resonator (B).
    Fig 2: Removing Resonator
    G03704620Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Install the parts in the reverse order of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.