2006 Honda Insight StandardFACTORY OEM SERVICE PROCEDURE

Driving Pattern

Fig 1: Identifying Driving Pattern
G04817770
  1. Start the engine. Hold the engine at 3,000 rpm with no load (in park or neutral) until the radiator fan comes on.
  2. Drive the vehicle at a speed between 25 - 55 mph (40 - 88 km/h) for at least 5 minutes.
  3. Then, drive at a steady speed between 55 - 75 mph (88 - 120 km/h) for at least 5 seconds.
  4. Decelerate with the throttle valve fully closed for at least 4 seconds.
  • If you have difficulty duplicating the DTC, retest after turning off electrical components such as the audio system and A/C, and try a different gear position.
  • Drive the vehicle in this manner only if the traffic regulations and ambient conditions allow.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.