Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Honda Insight StandardFACTORY OEM SERVICE PROCEDURE
Starter Performance Test
- Disconnect the wire from the S terminal.
- Make the connections as shown using as heavy a wire as possible (preferably equivalent to the wire used for the vehicle). To avoid damaging the starter, never leave the battery connected for more than 10 seconds.
- Connect the battery as shown. If the starter pinion moves out, it is working properly.
- Disconnect the negative battery terminal from the starter as shown. If the pinion retracts immediately, it is working properly.
- Clamp the starter firmly in a vise.
- Connect the starter to the battery as shown, and check that the motor turns and keeps rotating.
- If the electric current and motor speed meet the specifications when the battery voltage is at 11.5 V, the starter is working properly.
Specifications
Electric Current: 80 A or less
Motor Speed: 2,600 RPM or more
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.