Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P0700: Automatic Transaxle System: General Description
This DTC is used to determine if a malfunction is on the engine side or the A/T side when checking with the HDS. When a device on the A/T side malfunctions, the transmission control module (TCM) signals the engine control module (ECM) to turn on the MIL. If the ECM receives a signal from the TCM to turn on the MIL, the MIL is turned on and a DTC is stored.
| Execution | Continuous |
| Sequence | None |
| Duration | - |
| DTC Type | One drive cycle, MIL ON |
| Condition | Β |
|---|---|
| Ignition switch | ON |
| No active DTCs | A/T System |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
