2005 Honda Pilot EXFACTORY OEM SERVICE PROCEDURE

Starter Replacement

  1. Make sure you have the anti-theft codes for the radio and the navigation system, then write down the customer's radio station presets.
  2. Disconnect the negative cable from the battery first, then disconnect the positive cable.
  3. Remove the harness clamp (A).
  4. Disconnect the starter cable (B) from the B terminal, then disconnect the BLK/WHT wire (C) from the S terminal.
    Fig 1: Disconnecting Starter Cable From B Terminal And BLK/WHT Wire From S Terminal
    G04545423Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Remove the two bolts holding the starter, then remove the starter.
  6. Install in the reverse order of removal. Make sure the crimped side of the ring terminal is facing out.
  7. Connect the battery positive cable to the battery first, then connect the negative cable.
    Fig 2: Connecting Battery Positive Cable To Battery
    G04545424Courtesy of AMERICAN HONDA MOTOR CO., INC.
  8. Start the engine to make sure the starter works properly.
  9. Enter the anti-theft codes for the radio and the navigation system.
  10. Enter the customer's radio station presets, and set the clock.
  11. Reset the power window control unit (see RESETTING THE POWER WINDOW CONTROL UNIT ).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.