Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Honda Element 2WD L4-2.4LFACTORY OEM SERVICE PROCEDURE
CMP Sensor B Replacement
CMP Sensor B Replacement
1. Remove the air cleaner.
2. Remove the EVAP canister purge valve.
3. Disconnect the CMP sensor B connector (A).
4. Remove CMP sensor B (B).
5. Install the sensor in the reverse order of removal with a new O-ring (C).
1. Remove the air cleaner.
2. Remove the EVAP canister purge valve.
3. Disconnect the CMP sensor B connector (A).
4. Remove CMP sensor B (B).
5. Install the sensor in the reverse order of removal with a new O-ring (C).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.