Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Honda Element 2WD L4-2.4LFACTORY OEM SERVICE PROCEDURE
CMP Pulse Plate Replacement
CMP Pulse Plate A Replacement
1. Remove the cylinder head cover.

2. Hold the camshaft with an open-end wrench, then loosen the bolt.

3. Remove the Camshaft Position (CMP) pulse plate A.
4. Install the CMP pulse plate A in the reverse order of removal.
CMP Pulse Plate B Replacement
1. Remove the cylinder head cover.

2. Hold the camshaft with an open-end wrench, then loosen the bolt.

3. Remove the Camshaft Position (CMP) pulse plate B.
4. Install the CMP pulse plate B in the reverse order of removal.
1. Remove the cylinder head cover.
2. Hold the camshaft with an open-end wrench, then loosen the bolt.
3. Remove the Camshaft Position (CMP) pulse plate A.
4. Install the CMP pulse plate A in the reverse order of removal.
CMP Pulse Plate B Replacement
1. Remove the cylinder head cover.
2. Hold the camshaft with an open-end wrench, then loosen the bolt.
3. Remove the Camshaft Position (CMP) pulse plate B.
4. Install the CMP pulse plate B in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
