Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Honda Element 2WD L4-2.4LFACTORY OEM SERVICE PROCEDURE
Set/Resume/Cancel Switch
Cruise Control Set/Resume/Cancel Switch Test/Replacement
1. Remove the driver's airbag.

2. Remove the cover (A), then remove the set/resume/ cancel switch (B).

3. Check for continuity between the terminals in each switch position according to the table.
- If there is continuity, and it matches the table, but switch failure occurred on the cruise control actuator input test, check and repair the wire harness on the switch circuit.
- If there is no continuity in one or both positions, replace the switch.
1. Remove the driver's airbag.
2. Remove the cover (A), then remove the set/resume/ cancel switch (B).
3. Check for continuity between the terminals in each switch position according to the table.
- If there is continuity, and it matches the table, but switch failure occurred on the cruise control actuator input test, check and repair the wire harness on the switch circuit.
- If there is no continuity in one or both positions, replace the switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
