Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Honda CR-V SEFACTORY OEM SERVICE PROCEDURE
IMT Valve Replacement
- Remove the intake manifold (see INTAKE MANIFOLD REMOVAL AND INSTALLATION ).
- Disconnect the vacuum hose (A).
- Remove the bolts (B).
- Remove the IMT actuator assembly (C).NOTE:
- When installing the IMT actuator, make sure the bearing (D) is in place.
- Make sure the IMT assembly does not interfere with the intake manifold (E).
- When installing the IMT actuator, replace the O-rings (F).
- Install the IMT actuator assembly (A) so the hole (B) is visible.
- Turn the IMT actuator assembly (A), and align the bolt holes.NOTE: When turning the IMT actuator assembly, make sure the stop (B) fits into the groove (C).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
