2005 Honda CR-V EX, AutomaticFACTORY OEM SERVICE PROCEDURE

IMT Valve Replacement

  1. Remove the intake manifold (see INTAKE MANIFOLD REMOVAL AND INSTALLATION ).
  2. Disconnect the vacuum hose (A).
    Fig 1: Installing The IMT Actuator With Torque Specifications
    G03674310Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the bolts (B).
  4. Remove the IMT actuator assembly (C).
    NOTE:
    • When installing the IMT actuator, make sure the bearing (D) is in place.
    • Make sure the IMT assembly does not interfere with the intake manifold (E).
    • When installing the IMT actuator, replace the O-rings (F).
  5. Install the IMT actuator assembly (A) so the hole (B) is visible.
    Fig 2: Installing IMT Actuator Assembly So Hole Is Visible
    G03674311Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Turn the IMT actuator assembly (A), and align the bolt holes.
    NOTE: When turning the IMT actuator assembly, make sure the stop (B) fits into the groove (C).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.