Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Ignition Timing Inspection
- Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2 on HOW TO USE THE HDS (HONDA DIAGNOSTIC SYSTEM)
), and check for DTCs.
If a DTC is present, diagnose and repair the cause before inspecting the ignition timing.
- Start the engine. Hold the engine speed at 3,000 rpm without load (in Park or Neutral) until the radiator fan comes on, then let it idle.
- Check the idle speed (see IDLE SPEED INSPECTION ).
- Select "SCS" mode using the HDS.
- Free the service loop from the wire harness, then connect the timing light to the service loop.
- Aim the light toward the pointer (A) on the cam chain case. Check the ignition timing under a no load condition (headlights, blower fan, rear window defogger, and air conditioner are off).
Ignition Timing
M/T: 8°+/-2° BTDC (RED mark (B)) during idling in Neutral
A/T: 8°+/-2° BTDC (RED mark (B)) during idling in Park or Neutral
- If the ignition timing differs from the specification, check the cam timing. If the cam timing is OK, update the engine control module (ECM)/powertrain control module (PCM) if it does not have the latest software (see ECM/PCM UPDATING AND SUBSTITUTION FOR TESTING ), or substitute a known-good ECM/PCM (see HOW TO SUBSTITUTE THE ECM/PCM ), then recheck. If the system works properly, replace the ECM/PCM (see ECM/PCM REPLACEMENT ).
- Turn the ignition switch OFF.
- Disconnect the HDS and the timing light.
- Secure the service loop to the wire harness with wire ties.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
