Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2005CR-V 2WD L4-2.4LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINETIMING COMPONENTSSYSTEM SPECIFICATIONS
2005 Honda CR-V 2WD L4-2.4L
System Specifications
2005 Honda CR-V 2WD L4-2.4LSECTION System Specifications
Timing chain tensioner
6 x 1.0 mm 12 Nm (1.2 kgf-m, 8.7 ft. lbs.)
Crankshaft pulley
Install the crankshaft pulley, and hold the pulley with holder handle (A) and holder attachment (B).
Tighten the bolt to 50 Nm (5.0 kgf-m, 36 ft. lbs.) with a torque wrench and 19 mm socket (C). Do not use an impact wrench.
Tighten the pulley bolt an additional 90°.
Chain case cover
6 x 1.0 mm 12 Nm (1.2 kgf-m, 8.7 ft. lbs.)
6 x 1.0 mm 12 Nm (1.2 kgf-m, 8.7 ft. lbs.)
Crankshaft pulley
Install the crankshaft pulley, and hold the pulley with holder handle (A) and holder attachment (B).
Tighten the bolt to 50 Nm (5.0 kgf-m, 36 ft. lbs.) with a torque wrench and 19 mm socket (C). Do not use an impact wrench.
Tighten the pulley bolt an additional 90°.
Chain case cover
6 x 1.0 mm 12 Nm (1.2 kgf-m, 8.7 ft. lbs.)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.