2004 Honda S2000FACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Switches

SWITCHES LOCATION

Component Location
A/C Pressure Switch On receiver drier, behind center of front bumper. See Figure .
Back-Up Light Switch On left side of transmission. See Figure .
Brake Fluid Level Switch On master cylinder reservoir. See Figure .
Brake Pedal Position Switch On brake pedal support. See Figure .
Clutch Interlock Switch On clutch pedal support. See Figure .
Clutch Pedal Position Switch Under left side of dash. See Figure .
Convertible Top Disable Switch Connector (Removable Hardtop) Behind rear left side trim. See Figure .
Door Switch (Driver's & Passenger's) Behind left & right rear side trim. See Figure .
Driver's Seat Belt Switch Connector Under driver's seat. See Figure .
Parking Brake Switch Connector At base of parking brake lever. See Figure .
Radiator Fan Switch On lower left side of radiator. See Figure .
Security Hood Switch At front of engine compartment. See Figure .
VTEC Oil Pressure Switch On right front of engine. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.