Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2004S2000 L4-2.2LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYSYSTEM SPECIFICATIONSTORQUE SPECIFICATIONS
2004 Honda S2000 L4-2.2L
Torque Specifications
2004 Honda S2000 L4-2.2LSECTION Torque Specifications
| Cylinder Head Bolts | ||
| 1st Step in Sequence | 29 Nm | |
| 2nd Step | 90° | |
| 3rd Step | 90° | |
| If Using New Head Bolts Tighten An Additional | 90° | |
| Tighten the two 8mm Bolts (A) | 22 Nm | |
| Intake Manifold Bolts | ||
| 8 x 1.25 | 22 Nm | |
| Camshaft Bearing Cap Bolts | ||
| 22 Nm | ||
| Main Bearing Cap Bolts | ||
| 1st Step | 29 Nm | |
| 2nd Step | 60° | |
| 8 mm Bolts | 22 nm | |
| Connecting Rod Cap Bolts | ||
| 1st Step | 25 Nm | |
| 2nd Step | 90° | |
| Crankshaft Pulley Bolt | ||
| 245 Nm | ||
| Flywheel Bolts M/T | ||
| 127 Nm | ||
| Oil Pump Bolts | ||
| 8 x 1.25 mm | 22 Nm | |
| 6 x 1.0 mm | 12 Nm | |
| Exhaust Manifold Nuts | ||
| 31 Nm | ||
| Water Pump Bolts | ||
| 8 x 1.25 mm | 22 Nm | |
| 10 x 1.25 mm | 44 Nm |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.