Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2004S2000 L4-2.2LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSBRAKES AND TRACTION CONTROLSYSTEM SPECIFICATIONSSERVICE SPECIFICATIONS
2004 Honda S2000 L4-2.2L
Service Specifications
2004 Honda S2000 L4-2.2LSECTION Service Specifications
FRONT
Brake disc runout
Service limit 0.10 mm (0.004 inch)
Maximum refinish limit 23.0 mm (0.91 inch)
Brake disc thickness
Standard 24.9 - 25.1 mm (0.98 - 0.99 inch)
Maximum refinishing limit 23.0 mm (0.91 inch)
Brake disc parallelism 0.015 mm (0.0006 inch) maximum
REAR
Brake disc runout
Service limit 0.10 mm (0.004 inch)
Maximum refinishing limit 10.0 mm (3/8 inch)
Brake disc thickness
Standard 11.9 - 12.1 mm (0.469 - 0.476 inch)
Maximum refinishing limit 10.0 mm (0.39 inch)
Brake disc parallelism 0.015 mm (0.0005 inch) maximum
Brake disc runout
Service limit 0.10 mm (0.004 inch)
Maximum refinish limit 23.0 mm (0.91 inch)
Brake disc thickness
Standard 24.9 - 25.1 mm (0.98 - 0.99 inch)
Maximum refinishing limit 23.0 mm (0.91 inch)
Brake disc parallelism 0.015 mm (0.0006 inch) maximum
REAR
Brake disc runout
Service limit 0.10 mm (0.004 inch)
Maximum refinishing limit 10.0 mm (3/8 inch)
Brake disc thickness
Standard 11.9 - 12.1 mm (0.469 - 0.476 inch)
Maximum refinishing limit 10.0 mm (0.39 inch)
Brake disc parallelism 0.015 mm (0.0005 inch) maximum
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.